Initial Start-Up - AEG DDLE ÖKO TD 27 Bedienung Und Installation

18 Nm
1
9.3.6 Remote temperature control installation
The transmitter can be fitted to the wall with the wall
mounting bracket. The wall mounting bracket can be se-
cured to the wall with the adhesive tape supplied or with
a suitable countersunk screw Ø 3 mm or smaller.
Standard delivery - remote temperature control
OFF
3s
1
1 Transmitter incl. battery
2 Wall mounting bracket
3 Adhesive pad

10. Initial start-up

10.1 Appliance
24
2 3
10.2 Anti-scalding protection / Temperature
10.3 Remote temperature control FBM
Commissioning must only be carried out by a heating
contractor.
1
4
5
» Fill and vent the appliance. Please note - boil-dry risk
(1).
Open and close all connected taps several times,
until all air has been vented from the pipework and
the appliance.
» Activate the safety pressure limiter (2) at flow pres-
sure by pressing the reset button. The appliance is
supplied with the safety pressure limiter in the trig-
gered state.
» Push the temperature selector cable plug onto the
PCB (3).
» Fit the appliance cover.
Attach the cover at the top of the appliance. Pivot it
to the back panel. The cover must click audibly into
place (4).
Check the firm seat of the appliance cover.
» Switch the mains power ON (5).
» Check the appliance function.
limit
In customer service mode, you can limit the temperature
within the range 31 ... 60 °C.
Comfort
The remote temperature control is registered with the ap-
pliance at the factory. If there is no data communication
during commissioning, carry out the pairing process as
follows: Use the ECO button to select the comfort function
"Remote temperature control (rc)", press memory button
1 on the appliance (this enables the pairing phase; the
bar graph indication on the display runs), then press any
button on the remote temperature control.
Installation
2
3
35