Herunterladen Inhalt Inhalt Diese Seite drucken

Completing The Installation; Commissioning; Initial Start-Up - AEG DDLE Basis 11 Bedienung Und Installation

Elektronisch geregelter komfort-durchlauferhitzer
Vorschau ausblenden Andere Handbücher für DDLE Basis 11:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Installation
» Slide the lower section of the back panel under the
tap connection pipes. Click the lower back panel
section into place.
» Secure the connection pipes to the appliance.
10.2.6 Operation with preheated water
You can restrict the maximum inlet temperature by install-
ing a central thermostatic valve.
10.2.7 Temperature limit
CAUTION Burns
When operating with preheated water, the set tem-
perature limit may be ineffective.
» In this case, limit the temperature with an up-
stream central thermostatic valve.
You can adjust the temperature limit inside the appliance
cover.
1
1 Position "Tred" (55 °C): Temperature limit
2 Position "Tmax": No temperature limit, for tempera-
ture setting range, see chapter "Specification / Data
table".

10.3 Completing the installation

» Open the shut-off valve in the twin connector or the
cold water inlet line.

11. Commissioning

WARNING Electrocution
Commissioning must only be carried out by a qual-
ified contractor in accordance with safety regula-
tions.
26

11.1 Initial start-up

2
11.2 Recommissioning
3
L3'
4
L2'
1
L1'
2
1.
» Open and close all connected draw-off valves sever-
al times, until all air has been purged from the pipe-
work and the appliance.
» Carry out a tightness check.
» Activate the safety pressure limiter by firmly pressing
in the reset button (safety pressure limiter disabled in
the delivered condition).
» Plug the temperature selector cable plug into the
PCB.
» Fit the appliance cover. The appliance cover must
audibly click into place. Check that the appliance
cover is seated correctly.
» Switch the power supply ON.
» Calibrate the temperature. Turn the temperature se-
lector fully clockwise then fully anti-clockwise.
» Check the appliance function.
Appliance handover
» Explain the functions of the appliance to the user.
Show the user how to operate the appliance.
» Make the user aware of potential dangers, especially
the risk of scalding.
» Hand over these instructions.
» Vent the appliance and the cold water inlet line (see
chapter "Operation / Settings").
» See chapter "Installation / Installation / Commission-
ing / Initial start-up".
2.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis