AEG DDLE ÖKO TD 27 Bedienung Und Installation Seite 33

» Seal in both twin nipples before fully inserting them.
Insert both twin nipples into the wall plates.
» Thoroughly flush the cold water supply line.
Note
Never use the shut-off valve in the cold water inlet
to reduce the flow rate.
9.2.6 Fitting the cable grommet
» Push the cable grommet over the power cable.
9.2.7 Preparing the back panel
» Break out the cable grommet knock-out in the back
panel.
If the wrong knock-out has been opened by mistake, a
new back panel must be used.
9.2.8 Appliance installation
» Remove the protective transport plugs from the
water connections.
» Push the back panel over the threaded stud and the
cable grommet. Pull the cable grommet by the lock-
ing hooks into the back panel using pliers, until both
locking hooks audibly click into place.
» Push the back panel firmly and flush against the wall.
Lock the back panel in place using the fixing toggle.
9.2.9 Water connection
» Fit the threaded connections with flat gaskets onto
the twin nipples. Ensure that the bayonet closures
inside the appliance are not twisted.
9.2.10 Making the electrical connection
» Connect the power cable to the mains terminal (see
chapter "Wiring diagram").
WARNING Electrocution
Ensure that the appliance is earthed.
9.2.11 Fitting the base part of the back panel
» Push the lower back panel section onto the upper
section of the back panel and ensure that it clicks
into place.
9.2.12 Completing the installation process
» Align the mounted appliance by undoing the fixing
toggle, aligning the power supply and back panel,
and then re-tightening the fixing toggle. If the back
panel of the appliance is not flush against the wall,
secure the appliance with a screw in the lower
section.
9.2.13 Remote temperature control installation
The transmitter can be fitted to the wall with the wall
mounting bracket. The wall mounting bracket can be se-
cured to the wall with the adhesive tape supplied or with
a suitable countersunk screw Ø 3 mm or smaller.
Installation
33