Appliance Description - AEG DDLE ÖKO TD 27 Bedienung Und Installation

Installation

8. Appliance description

The bare wire heating system is suitable for hard and soft
water areas (see chapter "Application areas").
8.1 Unit layout
1 Rotary selector with buttons and display
2 Appliance cover
3 Lower back panel section
4 Threaded DHW fitting
5 Threaded cold water fitting
6 Back panel top section
7 PCB
8 Coding card for changing the output to 18, 21 or 24 kW (on ap-
pliances with output selection)
9 Plug-in position from the temperature selector cable
10 Safety pressure limiter (AP 3) with reset button
11 Mains terminal
12 Knock-out for power connection from above
13 Fixing toggle
14 Outlet sensor
30
14
15
16
17
18
2
1
19
5
4
20
3
21
22
23
38°
OFF
3s
24
55°
25
28
15 High limit safety cut-out with reset button
16 Heating system
17 Flow rate sensor
18 Plug from temperature selector to "set T"
19 Type plate
20 Mounting bracket
21 Threaded stud for mounting bracket
22 Cable grommet (power cable from above/below)
23 Twin nipple 2 x (cold water with shut-off valve)
24 Flat gaskets
25 Screws, rawl plugs for securing the lower back panel
26 Operating and installation instructions
27 Installation template
28 Remote temperature control FBM Comfort
13
12
11
10
9
8
7
6
27
26