Inhaltsverzeichnis
Werbung
English
Presentation Using Film
[A]
„ Setting the main unit
After folding the lamp onto the main unit as shown in Figure A, and then connecting a
projector or PC monitor, turn on the power.
„ Setting the slide shooting adapter
Cover and place the supplied slide shooting adapter on the lamp head, and adjust the
position while watching the screen, so that the opening of the slide shooting adapter points
to the center of the screen. (Figure B)
„ Adjusting the size
Set the film or slides in the slide shooting adapter as shown in Figure C, and then use the
zoom buttons [
fit the screen size.
„ Adjusting the focus
In normal AF mode, the focus is automatically adjusted. In One-shot AF mode, the focus is
adjusted by pressing the [AF] button on the operating panel or on the remote control.
„ Adjusting the brightness
If the screen is too bright or too dark, you can adjust the brightness from [Brightness] on
the OSD setting menu or by using the [BRIGHTNESS
the remote control.
N o t e
• Depending on the film, change the display setting from the [
menu to [Posi] or [Nega], or use the [Posi/Nega] button on the remote control.
• If you feel that the screen is too dark even after adjusting the brightness, you can
improve the brightness by placing a white sheet of paper on the stage and then
attaching the slide shooting adapter.
112
[B]
Slide
[C]
/
] on the operating panel or the remote control to adjust the slide to
Slide shooting adapter
Film
Pass film through clips
]/ [BRIGHTNESS
Posi/Nega] OSD setting
] buttons on
Werbung
Inhaltsverzeichnis
