Instrument And Control Functions; Right Handlebar Switches; Seat - Yamaha FJR1300AP Ergänzende Wartungsanleitung

INSTRUMENT AND CONTROL
FUNCTIONS

RIGHT HANDLEBAR SWITCHES

PATROL SWITCH
Patrol switch "1" activates the siren or flashing
light.
It is used when a siren or flashing light is in-
stalled.
OFF
○
This is for the flashing light.
This is for both siren and flash-
ing light.
HAZARD SWITCH
With the key in the "ON" or "P" position, use
hazard switch "1" to turn on the hazard lights
(simultaneous flashing of all turn signal lights).
The hazard lights are used in case of an emer-
gency or to warn other drivers when your vehi-
cle is stopped where it might be a traffic hazard.
Do not use the hazard lights for an extended
length of time with the engine not running,
otherwise the battery may discharge.

INSTRUMENT AND CONTROL FUNCTIONS

SEAT

TO REMOVE THE SEAT
1. Insert the key into the seat lock, and then
2. Lift the rear of the seat and pull it off.
TO INSTALL THE SEAT
1. Insert the projection on the front of the seat
1
2. Remove the key.
1
4
turn it counterclockwise.
1. Seat lock
2. Unlock
into the seat holder as shown, and then push
the rear of the seat down to lock it in place.
1. Projection
2. Seat holder
Make sure that the seat is properly secured
before riding.
The seat height can be adjusted to change
the riding position.