Yamaha FJR1300AP Ergänzende Wartungsanleitung Seite 45

A-A A-A
1. Rear flashing light
2. Clamp
3. Wire lead
4. Rear flashing light lead
5. Plastic band (L = 108.5 mm)
6. Rear turn signal light lead
7. Rear turn signal light
8. Rear flashing light stay
9. Rear bracket
10. Tail cover
11. Plastic band (L = 172.5 mm)
A. The connected leads must not be located
below the rear fender.
B. Install in alignment with the top edge of the
rear bracket.
C. Clamp the rear turn signal light lead and
rear flashing light lead at the top of the rear
bracket. Face the end of the plastic locking
tie outward.
RECOMMENDED SPECIFICATIONS
B-B
C
D
D. Route the rear turn signal light lead on the
outside of the bolt.
E. The clamp ends facing inward.
F. The clamp ends facing outward.
39
C-C
B
A
B
A
D
C
D-D