Yamaha FJR1300AP Ergänzende Wartungsanleitung Seite 43

1. Sub-battery
2. Wire harness assembly
3. Controller sub-lead
4. Plastic band (L = 108.5 mm)
5. Plastic band (L = 202 mm)
6. Flashing light and siren relay
7. Wire lead
8. Sub-lead wire
9. Rear combination light lead
10. License plate light lead
A. Clamp the wire harness assembly and con-
troller sub-lead. Set the clamp end outward
without cutting it off.
B. Clamp the controller sub-lead below the
rear frame. Set the clamp end outward
without cutting it off.
C. Bundle and clamp the wire lead. Set the
clamp end backward without cutting it off.
D. Clamp the controller sub-lead, rear combi-
nation light lead, and license plate light
lead.
E. Clamp the wire harness assembly and con-
troller sub-lead.
F. Clamp the wire harness assembly to the
rear frame. Set the clamp end forward with-
out cutting it off.
G. To rear right turn signal light
H. To auxiliary instruments switch
I. To rear left turn signal light
J. To controller
K. Clamp the wire lead. Bundle the lower por-
tion of the wire lead with its clamped end
facing outward.
RECOMMENDED SPECIFICATIONS
37