Yamaha FJR1300AP Ergänzende Wartungsanleitung Seite 26

1. Coupler (for controller)
2. Coupler (for microphone)
3. Coupler (for front flashing light)
4. Headlight beam adjusting cable
5. Clamp
6. Wire harness assembly
7. Right handlebar switch lead
8. Identification red tape
A. Route the wire harness assembly at the
back of the headlight beam adjusting cable.
B. Route the wire harness assembly along the
bottom of the square pipe frame and clamp
it at the white tape. Direct the clamp end
downward.
C. Route the wire harness assembly just at
the head.
D. To the turn signal light and horn
E. To the main battery, including the speaker,
etc.
F. Connect the headlight lead and wire har-
ness assembly. (Connect the couplers of
the identical color.)
G. Fix the headlight cord and wire harness as-
sembly to the headlight mounting stay with
the clamp. Leave the clamp end to lie on
the inside of the cowling.
H. Route the clamp through the hole in the
stay and fix the wire harness assembly at
the white tape. Cut off the clamp end.
I. Route the wire harness assembly under
the stay.
J. To the extension wire lead under the fuel
tank
K. To the handlebar switch lead and siren
L. Clamp the wire harness assembly at the
white tape together with the headlight lead.
Direct the clamp end downward.
20
MAINTENANCE