Cleaning - RAIS/attika VIVA L GAS-Serie Benutzerhandbuch

English

Cleaning

It is advisable to clean the stove of dust and foreign bodies each new heating season
and especially if the stove has not been used for a long time� This can be done with a
soft brush and a vacuum cleaner� Or with a damp cloth with a non-abrasive cleaning
agent� Do not use corrosive or abrasive substances to clean this stove� The stove should
be cold when cleaning and taking care of it�
If the glass is sooty:
• Only clean the glass when the stove is cold�
• Cleaning should be done with glass cleaner, which can be purchased from your
RAIS dealer�
External cleaning is done using a soft cloth or brush�
Before each new heating season, the chimney and flue gas connection piece should
always be checked for blockages� Check the stove externally and internally for damage�
Check gaskets in particular� Only original spare parts may be used�
Cleaning of ceramic logs.
Remove the ceramic logs as described in points 1 - 4 under Service.
Clean the ceramic parts carefully with a soft brush and a vacuum cleaner�
Only replace damaged parts with original Rais specified parts�
Pack scrap ceramics in plastic bags and deliver to the correct waste locations�
It is recommended using a vacuum cleaner with a HEPA filter system�
Replace embers and close the door� Ensure the stove works correctly and is safe to use�
Servicing of the Burners.
(See section Conversion to bottled gas if necessary)
Remove the ceramic logs as described in points 1 - 4 under Service.
The pilot plate guard is removed by loosening the two M5 screws with a 4 mm hex key�
By removing the two screws on the pilot unit with a 7 mm open-ended spanner, the pi-
lot unit can be raised a little� Fittings on the underside of the pilot unit can be loosened
by means of a 10 mm open-ended spanner� The thermosensor and pilot burner can be
replaced�
To gain access to the nozzles on the main burner, the main burner unit must be re-
moved from the stove� This is done by removing the 4 bolts holding the burner in place�
Now the burner can be lifted out of the combustion chamber� Now there is free access
to the nozzles�
When parts are replaced, only replace these with original Rais specified parts�
51
attika
RAIS/ - User manual for VIVA L Gas