In Standby Mode (Pilot Light) - RAIS/attika VIVA L GAS-Serie Benutzerhandbuch

English
HOW TO IGNITE
When pilot ignition is confirmed, the motor auto-
matically goes to maximum flame height�
One-button operation of handset
(Default setting)
NB!
Move from one-button to two-button ignition by
pressing and holding down the
seconds immediately after inserting the batteries�
ON is displayed, and 1 flashes� When the change
is made 1 changes to 2�
NB!
Move from two-button to one-button ignition by
pressing and holding down the
seconds immediately after inserting the batteries�
ON is displayed, and 2 flashes� When the change
is made 2 changes to 1�
If the pilot light does not ignite after several
attempts, turn the main valve button to OFF� Then
follow the guidance for "SHUTTING OFF GAS TO
APPLIANCE"
•Press the button until
you hear a short beep and a
series of flashing lines con-
firm that the start sequence
has commenced� Then
release the button�
•The main gas supply starts
as soon as pilot ignition is
confirmed�
•The handset automatically
goes into Manual mode
after ignition of the main
burner�
button for 10
Two-button operation of
handset
•Press the and buttons
at the same time until you
hear a short beep and a se-
ries of flashing lines confirm
that the start sequence has
commenced� Then release
the buttons�
•The main gas supply starts
as soon as pilot ignition is
confirmed�
•The handset automatically
goes into Manual mode
after ignition of the main
burner�
button for 10
attika
RAIS/ - User manual for VIVA L Gas

IN STANDBY MODE (PILOT LIGHT)

HANDSET
•Press and hold down the
ance to pilot light�
HOW TO EXTINGUISH THE FIRE
ADJUSTMENT OF FLAME
HEIGHT
SELECTING LOW FLAME and HIGH
FLAME
NOTE: The background light must be on in order
to obtain double-click operation with high and low
flame�
button to set the appli-
HANDSET
•Press the button to
EXTINGUISH
NOTE:
There will be a delay
of 5 seconds before it is
possible to re-ignite�
Handset
•The flame height is
increased by pressing and
holding down the button�
•To reduce the flame height
or set the appliance to pilot
flame, press and hold down
the button�
•Low flame is activated
by double-clicking on the
button LO is displayed�
NOTE:
The flame goes to
high first before going to
low flame�
44