Commissioning - RAIS/attika VIVA L GAS-Serie Benutzerhandbuch

English

Commissioning

Check functioning of pilot light.
See User Instructions for use of remote control�
1� Start the pilot light�
2� Check that the pilot light remains ignited�
3� Turn off the pilot light�
Check the functioning of the main burner.
1� Turn on the pilot light
2� Turn on the main burner�
3� Check that the cross-ignition from the pilot light to the main burner
occurs easily and that the main burner and pilot light remain ignited�
4� Check that the secondary burner's functions work�
5� Turn the stove off entirely�
Press Test
The stove is preset to provide the correct amount of heat (kW) as de-
scribed under specifications� There is no need for further adjustment�
"Inlet pressure" and "Burner pressure" must ALWAYS be measured�
1� Close the gas valve (Main Valve Knob)
2� Open the "Inlet pressure tap" on the gas valve and connect a ma-
nometer�
3� Check that the pressure measured concurs with the prescribed pres-
sure from the gas supply company�
4� Carry out the test when the stove is at maximum heat output, includ-
ing the secondary burners and when the stove only has the pilot light
ignited�
5� If the pressure is low, check that the gas supply pipes are the correct
size�
6� If the pressure is too high (more than 5 mbar over), the stove can still
be installed but the gas supply company should be contacted�
7� The screw for the "Outlet pressure tap" on the gas valve is loosened
and a manometer connected
8� Check that the pressure measured concurs with the pressure stated
on the rating plate�
9� The value measured must be within ± 10% of the stated pressure� If
the pressure is not correct, the supplier should be contacted�
Note� After the pressure test and removal of the manometer, the
39
screws in the "pressure tap" should be retightened� Check the
system for gas leaks�
attika
RAIS/ - User manual for VIVA L Gas