De Dietrich DTI1102 series Einbau- Und Gebrauchsanweisung Seite 43

2 2 / / INSTALLING YOUR APPLIANCE
•
Adjust the burner power screws: they are
located under the knobs (Fig. 04) .
— Proceed one tap at a time.
— Remove the knobs and the gaskets by
pulling them up.
- Switching from
propane/butane-air gas to propane/butane
gas
-
With a small flat-head screwdriver, screw in
all the way the brass (yellow) burner power
screws (Fig. 05), in a clockwise direction.
-
Replace the gaskets and the knobs, paying
careful attention to their direction and
ensuring that the knobs are pushed in all the
way.
- Switching from butane/propane to natural
gas or butane-air gas/propane-air gas
-
Unscrew the brass (yellow) burner power
screws (Fig. 06) , using a small flat-head
screwdriver, turn twice counter-clockwise.
-
Replace the knob.
-
Light the burner in maximum heat mode,
then turn down to reduced heat mode.
-
Remove the knob again, then turn the
burner power screw clockwise until it
reaches the lowest possible setting that does
not extinguish the flame.
-
Replace the gasket and knob.
-
Make several attempts to shift from the
maximum flow rate to the minimum: the flame
should not go out; if it does, unscrew the
burner power screw so as to obtain good
flame retention during these position
switches.
-
Replace the burner heads, burner covers
and pan supports on the hob.
natural gas or
Fig. 04
Burner power
adjustment screw
Fig. 05
Fig. 06
43
EN
Knob
Spring
Base
Ring
Valve
Tap axis
Burner power
adjustment screw
Tap axis