SUOMY MX TOURER Handbuch Seite 33

USE and MAINTENANCE
Eng
REPLACEMENT WITH A CARTER FOR TRANSFORMATION INTO A FULL-FACE HELMET
See Figure 10a / b
The MX TOURER can be transformed into a full-face helmet by removing the peak and replacing
it a specific cover.
To carry out this transformation, you must first remove the peak following the instructions in the
section: PEAK Disassembly / Reassembly figure 9
After removing the peak you have to mount the two covers A and B and the small covers on the
sides of the shell.
figure 10a
Mounting the cover
To mount the covers you must first position them, ensuring you insert the two ends (C/D) inside
the rear air intakes located on the shell, and then pressing quite firmly in the (Y) direction on the
front part of the cover until it is attached to the front air intakes.
Then align the holes on the cover with the threaded bushes and tighten the screws (E and F)
using the special tool provided.
Removing the cover
figure 10b
To remove the cover, you must firstly remove its screws (E and F) using the special tool that comes
with the helmet.
Then press firmly on the outside of the helmet (X), thus allowing the detachment of the cover from
the front air intake, and then remove the cover from the rear air intake.
Protection covers on the sides See Figure 11
After removing the peak you have to mount the two small protection covers over the two holes on
the side. Align the small protection covers with the profile of the visor movement cover mechanism
and tighten the screws using the special tool provided.
figure 11
For all these operations, use a suitable tool to tighten the screws.
31