SUOMY MX TOURER Handbuch Seite 30

USE and MAINTENANCE
Eng
VISOR MECHANISM - Replacement
Removal
After removing the visor as shown in the previous paragraphs, loosen and remove the screw (A);
then remove the mechanism from the shell.
Assembly
The mechanisms (B) are not interchangeable. Before proceeding you need to identify the
respective assembly side; the mechanisms are identified by a letter stamped on the back
(L: left side when the helmet is worn - R: right side when the helmet is worn)
Place the mechanism on the cover, insert and tighten the screw (A).
After assembly, check that the mechanisms are in place and securely fastened to the shell.
Then install the visor and adjust it as described above.
Once you have finished the assembly, check that the visor is securely fastened to the
helmet, that it turns freely and locks properly in the locking positions.
If this does not happen and the visor's rotation mechanism does not work properly, refrain
from using the helmet and contact Suomy authorised personnel only.
SUN VISOR
The inner sun visor, as well as the outer visor, should be regularly cleaned and checked.
The presence of dirt and/or deep scratches on the surface of the visor may be due to
abnormal light reflections or aberrations, which diminish riding safety. Immediately replace
the visor if such defects are found.
28
See Figure 6
figure 6
figure 7