SUOMY MX TOURER Handbuch Seite 31

Movement
MX TOURER has a retractable sun visor which can slide into the gap between the outer shell and
the polystyrene. There is no intermediate locking point between the positions of the visor when it
is fully closed or fully open.
The movement of the inner sun visor is carried out using the button located at the back on
of the MX Tourer, on the left (See Figure 7).
Pressing the button in one of the two directions X and Y respectively determines the opening or
reinsertion of the visor inside the helmet.
The movement must always be completed until the final positions of the button are reached.
Disassembly
To disassemble, position the sun visor in the open position (visor lowered) using the relevant
button (see visor movement).
Once the fully open position is reached, in order to disassemble you have to remove the position
lock by pressing quite firmly in the (X) direction until reaching a rotation where the upper edge of
the visor reaches over the upper edge of the helmet ( A). Once the rotation has gone beyond the
locking point, all you need to do is press firmly on both sides towards the outside of the helmet until
the fork is fully detached, with its rotation fulcrum positioned inside the shell on the right side of
the helmet (the side without the movement button), and up to the total detachment of the lever (b)
from the mechanism (c) on the left side (the side with the movement button), and therefore the
removal of the visor.
This operation must be performed on both sides but taking care to slide the visor firstly
from the side with the movement button, and only then from the other side.
USE and MAINTENANCE
See Figure 7
Figure 8 Removing a / b
Eng
figure 8a
figure 8b
29