Herunterladen Inhalt Inhalt Diese Seite drucken

SUOMY MX TOURER Handbuch Seite 32

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 52
USE and MAINTENANCE
Eng
Assembly
To ensure the best possible functioning of the visor, ensure that all parts (pins and their housings on the helmet) are perfectly clean.
Before inserting the visor ensure the external movement is in the open position (visor lowered).
Position the sun visor, taking care to align the fork with its rotation fulcrum inside the shell on the right side of the helmet. Then press very firmly
towards the inside of the helmet until the fork's inner insert is completely inserted. Then press down on the left side so that the tab (B) is inserted
in the mechanism's hollow cone (C). Then press firmly in the (W) direction until it is completely attached to the inner mechanism. A click can
be heard when it is correctly inserted. Slightly rotate the visor in the direction of insertion until it enters the shell's profile. Then try out some
movements using the specific button to check that it is working properly.
Once you have finished the assembly, check that the visor is securely fastened to the helmet, that it turns freely and locks properly
in the locking positions. If this does not happen and the visor's rotation mechanism does not work properly, refrain from using the
helmet and contact Suomy authorised personnel only.
PEAK
Disassembly/Reassembly
Loosen and remove the four screws on the sides and in the middle of the peak.
Then remove the peak by pulling it towards the front of the helmet (x direction), ensuring you
detach it from the constraint of the rear air intakes (A B).
To reassemble the peak you must firstly position the visor, ensuring you insert the two ends (A/B)
inside the air intakes located on the shell, and then pressing quite firmly in the (Y) direction on the
front part of the cover until it is fully attached. Then align the holes on the peak with the threaded
bushes and tighten the screws using the special tool provided.
For disassembly and reassembly of the peak, always use the special tool that comes with
the helmet.
30
See Figure 8 a / b
See Figure 9
figure 9

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis