SUOMY MX TOURER Handbuch Seite 26

USE and MAINTENANCE
Eng
INTERIOR COMFORT FEATURES
The interior comfort features of the Suomy MX TOURER are composed of an upper cap and pads,
both fully removable and washable.
They are made of high quality hypoallergenic fabric with antibacterial treatment.
INNER REMOVABLE CAP
Removal
The inner cap is attached to the inner shell by means of 7 attachment points, namely:
• two snap-on buttons placed at the back of the helmet and directly inserted in polystyrene (A B)
• two side straps (C-D)
• a frontal attachment system with three constraints inserted into a specific frame fixed directly to
the polystyrene using a co-moulding system patented by SUOMY. In order to remove the cap,
first pull out the back part by pulling it towards the inside of the helmet until the complete
detachment of the attachments A and B. Gently pull until they are completely detached from the
part fastened to the polystyrene. Detach the two side straps C and D. Finally, detach the two front
frames, one of which is a solid polystyrene frame and the other one which is integrated in the cap,
by careful pulling towards the interior of the helmet until the three constraint points (E F G) have
been completely freed.
Assembly
Place the cap inside the shell, taking care to align its edges with the edges of the inner shell made
of polystyrene. After positioning it, exert an even pressure on the attachment points between the
two frames (the one integrated with the cap and the other one inserted into polystyrene) in
particular taking care to align the three attachment points [E F G], until they have been fully hooked
onto. Align and then attach the two snap-on buttons (A and B), taking care to adhere the neck roll
to the shell's profile.
24
See Figure 3 a/b
figure 3a
figure 3b