Siemens SITRANS F-Serie Bedienungsanleitung Seite 33

5. The drop down menu lists the following sensor selections:
6. For this example, select the sensor model that appears on the sensor label then trigger
①
②
③
7. Trigger <Right Arrow> sensor to select [Transducer Size]. Scroll to select the transducer
8. At [Transducer Mount Mode], trigger <Right Arrow>. Scroll to select [Reflect] or [Direct]
9. IMPORTANT: Record Number Index and Spacing Method information. The data will be
10.Sensors can now be mounted. Refer to Sensor Installation (Page 32) mounting
11.After sensors are mounted refer to Final Setup (Page 36) to commission the meter.
FUH1010 IP65 NEMA 7 Interface Detector Quick Start
Operating Instructions, 06/2014, A5E02428148-AA
– 1011 Universal
– 1011HP-T1 - Usable -40 to 120°C, recommended for Ø Temperature <40°C;
Standard.
– 1011HP-T2 - Usable -40 to 120°C, recommended for Ø Temperature >40°C - <80°C;
Named as high temperature.
– 1011HP-T3 - Usable -40 to 120°C, recommended for Ø Temperature >80°C <120°C;
special request.
– 991 Universal
Note
The meter will automatically recommend a sensor depending on the application data
that has been entered.
<ENTER>.
Select based on type.
Select based on size.
After sensor is mounted select [Install].
size indicated on the sensor label. Trigger <ENTER> to select.
mount mode and trigger <ENTER>.
used to mount the sensors. Trigger <Down Arrow> as needed to locate data.
procedures and select the mounting mode desired.
Commissioning
3.4 Programming the Transmitter
31