Siemens SITRANS F-Serie Bedienungsanleitung Seite 27

4. Trigger <ENTER> sensor to save the Site name.
5. Trigger <Left Arrow> and return to [Channel Setup]. Trigger <Down Arrow> to select
FUH1010 IP65 NEMA 7 Interface Detector Quick Start
Operating Instructions, 06/2014, A5E02428148-AA
①
Note site name field is initially blank.
②
(?) indicates cell is ready to accept data. Cursor shown at 1st character position.
③
Insert desired name (8 Characters max.)
Note
To set English or Metric units: In Meter Type Menu, scroll to [Meter Facilities] menu.
Trigger <Right Arrow> and select desired units. Trigger <ENTER> to select. Trigger <Left
Arrow> and <Up Arrow> to return to [Meter Type] menu.
Note
To select alphanumeric characters: Trigger <Right Arrow> to cursor and then trigger
<Up/Down Arrow> to select letters and numbers.
[Pipe Data].
Note
After the site configuration procedures that follow are complete the newly created site
must be saved again to retain the new site data. Refer to the Save/Rename Site
procedure below.
Commissioning
3.4 Programming the Transmitter
25