Siemens SITRANS F-Serie Bedienungsanleitung Seite 26

Commissioning
3.4 Programming the Transmitter
4. Trigger <ENTER> sensor to select meter type: [Channel 1 Clamp-on] appears.
5. To select [Channel 1 Clamp-on] mode, trigger <Right Arrow> sensor.
6. Trigger <ENTER> sensor to select mode. [Channel Setup] menu will appear.
Note
IMPORTANT: Colon appears when menu item is selected for entry.
Create a Site
1. Trigger <Right Arrow> and then <Up/Down Arrows> to select [Create/Name Site].
2. Trigger <Right Arrow> again to select the "?" symbol (see figure below right).
3. To create site name use the <Up/Down> and <Right Arrow> to select a name.
24
①
ENTER Sensor
②
ENTER Target Symbol Sensor
③
Current Selection
④
Top level of Installation Menu
FUH1010 IP65 NEMA 7 Interface Detector Quick Start
Operating Instructions, 06/2014, A5E02428148-AA