Removing And Replacing The Main Broom - Nilfisk-Advance 56411002 OBSOLETE Bedienungsanleitung Und Ersatzteilliste

Removing and Replacing the Main Broom

The main broom can be removed from the rear of the rider sweeper. Proceed as follows to remove and replace the main broom:
1 Remove the hopper.
2 Lift up the rider sweeper at the rear.
3 Remove bolts 1, fig. 8 securing the broom to the drive rods 5 and 6.
4 Pull out broom 3.
5 Install the two alignment pins 2 and 2A (standard accessories) to the ends of the drive rods 5 and 6.
6 Slide the slots 4 on the new broom 3 over the alignment pins 2 and 2A.
NOTE: Engage pin 2 first.
7 Push the new broom onto the drive rods 5 and 6.
8 Remove the alignment pins 2 and 2A and secure the broom in position with bolts 1.
5
2a
4
1
3
Fig. 8 - Fitting the Main Broom
1 Brush fixing bolts
2/2A Accessory alignment pins
3 Main broom
4 Drive slots
5/6 Broom drive rods
Abb. 8 - Montage der Hauptebürste
1 Befestigungsschrauben der mitnehmerspindel
2/2A Mitgelieferte stifte zur vereinfachung der montage der bürste
3 Bürste
4 Mitnehmerkerben
5/6 Bürsten-mitnehmerspindel
27 - FORM NO. 56041325 / RETRIEVER 4000B
2
1
Fig. 8 - Montage Brosse Centrale
1 Vis de fixation brosse aux arbres d'entraînement
2/2A Pivots fournis pour faciliter le montage de la brosse
3 Brosse
4 Encoches d'entraînement
5/6 Arbres d'entraînement brosse
Fig. 8 - Montaje del Cepillo Central
1 Tornillos de fijación cepillo a los árboles de tracción
2/2A Pernos en dotación para facilitar el montaje del cepillo
3 Cepillo
4 Muescas de tracción
5/6 Arboles de tracción cepillo
6