Inhaltsverzeichnis
Werbung
Operation
Precautions
*
The rider sweeper must only be used by responsible and authorised personnel.
*
Always remove the key from the main switch 5, fig. 2 and apply the parking brake 8 fig. 2 before leaving the rider sweeper unattended.
*
Raise the brooms when leaving the rider sweeper parked to prevent the bristles from becoming deformed.
*
Do not park the rider sweeper on slopes.
Caution !
Check the level of electrolyte in the batteries before starting to use the rider sweeper.
Starting Work
1
Check that the brooms are raised off the floor (levers 2, 6).
2
Release the brake pedal 8.
3
Insert the key 5 in the key switch and turn it clockwise to power on the electrical circuits.
4
Switch on the suction fan, main broom, and side broom motors at switch 4.
5
Lower the main and side brooms by means of levers 2 and 6.
6
Press gradually on pedal 7 to drive the sweeper in the direction and at the speed required.
Fig. 2 - Controls Used For Starting Work
Abb. 2 - Bezugspunkte für die Erste
Inbetriebnahme der Kehrmaschine
Fig. 2 - Commandes Pour la Mise en
Service de la Balayeuse
Fig. 2 - Puntos Para La Primera Puesta en
Funcionamiento de La Moto-Barredora
Using the Rider sweeper
1
Avoid picking up pieces of string, wire, and bands etc. longer than 11-5/8" (30 cm). If such materials do get caught in the brooms, stop the rider sweeper
immediately and remove them.
2
When negotiating surfaces which are wet with rain or puddles, move lever 1 (fig. 1) to position C to shut off the suction.
3
Operate the filter shaker motor every 10-15 minutes during work. Take the opportunity to clean the filter when transferring the rider sweeper from one
point to another. To clean the filter, simply hold lever 1 (fig. 1) fully back in position V 3 or 4 times for 3 to 5 seconds at a time depending on the amount
of dust swept up.
4
To pick up large but light objects (such as paper, leaves, etc.), push down pedal 9, (fig. 2) to lift the front flap just for the time necessary for the objects
to pass underneath.
19 - FORM NO. 56041325 / RETRIEVER 4000B
Werbung
Inhaltsverzeichnis
Fehlerbehebung
