Kärcher VM R750 Gebrauchsanweisungenhandbuch Seite 82

OIL FILTER CARTRIDGE REPLACEMENT
Follow the procedure below.
1- Turn off the engine and remove
the ignition key.
2 - Let the engine cool down ade-
quately to avoid being burnt.
3 - Prepare a container to collect
any leak.
4 - Unscrew the filter (U) and re-
place it.
5 - Check the conditions of gasket
(V) and, if necessary, replace it.
6 -Lubricate the seal of the new car-
tridge before assembling it.
7 - Install the oil filter.
Important
Lock the screw to a torque of 25 Nm.
8 - Turn the engine on and keep it running
at idle speed for a few minutes to bring it
up to working temperature (70÷80°C).
9 -Turn off the engine and remove the igni-
tion key.
10-Wait a few minutes so that all the oil will
flow into the sump.
GB
11-Check that the oil in the tank is at the
correct level, and top up if necessary
(see "Controllo livello olio motore").
English
12-Check for any oil leaks
Warning - Caution
If any oil leaks are found, stop the engine
immediately and contact an authorised
service centre.
Important
Do not throw away any polluting material
in the environment. Carry out their dis-
posal in compliance with the relevant
legislation in force.
- 34 -
R750
gasket (V)
filter (U)
IDM-45300601500.tif
Maintenance information