Kärcher VM R750 Gebrauchsanweisungenhandbuch Seite 79

5 - Top up, if necessary, from plug
(P). As for the liquid quantity and
type, see "Specifications".
Important
The fluid level must be up to the
base of the neck into which the ra-
diator plug is screwed. For further
information, please consult the
documentation provided by the
manufacturer of the vehicle/de-
vice in which the engine is in-
stalled.
`
PROCEDURE FOR LOOSENING OR TENSIONING THE BELT (TYPE POLY-V)
Follow the procedure below.
1- Turn off the engine and remove
the ignition key.
2 - Let the engine cool down ade-
quately to avoid being burnt.
To loosen the belt: turn the tensioner
(A) anticlockwise until holes (B) cor-
respond. When holes correspond,
lock the tensioner with pin (C).
To tighten the belt: adjust the tensio-
ner (A) to extract the pin (C). Relea-
se the tensioner so as to restore the
required tension in the belt.
Warning - Caution
Before tightening the belt, make
sure that it is correctly positioned
in the pulley seats (see "Belt re-
placement (type Poly-V)").
English
load plug (P)
pin (C)
hole (B)
- 31 -
R750
IDM-45300601100.tif
tensioner (A)
IDM-45300601200.tif
Maintenance information
GB