Safety Information - Kärcher VM R750 Gebrauchsanweisungenhandbuch

SAFETY RULES
– During the design and construction phas-
es, the Manufacturer paid special atten-
tion to the aspects which are liable to
cause any risk for the safety and health of
people interacting with the engine. Be-
sides complying with the relevant legisla-
tion in force, he followed all the "rules for
a good construction technique". The pur-
pose of this information is making users
aware of the need to pay the utmost at-
tention to prevent any risk. Caution is
however imperative. Safety also de-
pends on all the operators who interact
with the engine.
– Read carefully the instructions contained
in the manual supplied and those applied
on the engine, in particular follow those
concerning safety. Spend some of your
time reading the instructions to avoid un-
pleasant accidents.
– Pay attention to the meaning of the sym-
bols in the applied plates; their shape and
colour have a specific meaning related to
safety. Keep them visible and follow the
stated information.
– Use the engine only for the tasks author-
GB
ised by the manufacturer and do not
tamper with any device to achieve a dif-
ferent performance from the intended
one.
– The staff carrying out any type of inter-
vention throughout the life of the engine
should have precise technical skills, spe-
cific abilities and experiences acquired
and acknowledged in this sector. The
lack of these requirements may cause
damages to people's safety and health.
– All the installation phases should have
been taken into account since the devel-
opment of the initial project. The designer
has to observe with the engine fixing
points and the general indications provid-
ed by the manufacturer.
English

SAFETY INFORMATION

– Carry out the handling of the engine in
compliance with the information stated
directly on the engine, on the packaging
and in the operating instructions supplied
by the manufacturer.
– When lifting or transporting unpacked en-
gines use means of appropriate load ca-
pacity which must be properly anchored.
– When lifting and transporting packaged
engines, means of appropriate load ca-
pacity as stated on the packaging itself.
– Before carrying out other transfers, cre-
ate the conditions required to guarantee
stability and to prevent any engine part
from being damaged.
– Before starting the installation, the install-
er has to implement a "safety plan" and to
follow the designer's indications. Do not
make changes to the engine components
for any reason.
– It is necessary to make sure that the in-
stallation area is fitted with all intake, fuel
supply and exhaust connections.
– The manufacturer cannot be held re-
sponsible for any damage resulting from
the misuse of the engine, from the failure
to follow the indications contained in this
manual and from any tampering with or
change made without the manufacturer's
authorization.
– If appropriate, before using the engine for
the first time, after gathering all the nec-
essary information, simulate a few trial
manoeuvres to identify the controls and
their main functions, especially those re-
lated with starting and stop operations.
- 10 -
R750
Safety information