YASKAWA GA500 Serie Installations- Und Bedienungansleitung Seite 15

Sym
Name
bol
A USB Terminal
RUN Key
B
STOP Key
C
LO/RE LED
D
ALM/ERR LED
E
READY LED
F
YASKAWA TOMPC71061753A YASKAWA AC Drive GA500 Installation and Operation Instruction
Table 1.1 Keypad: Names and Functions
Insertion point for a USB cable. Uses a USB cable (USB standard 2.0, type A - mini-B) to
connect the keypad to a PC.
Starts the drive in LOCAL Mode.
Starts the operation in Auto-Tuning Mode.
Note:
Before you use the keypad to operate the motor, push
drive to LOCAL Mode.
Stops drive operation.
Note:
Uses a stop-priority circuit. Push
when a Run command is active at an external Run command source (REMOTE Mode).
To disable priority, set o2-02 = 0 [STOP Key Function Selection = Disabled].
Illuminated: The keypad controls the Run command (LOCAL Mode).
OFF: The control circuit terminal or serial transmission device controls the Run command
(REMOTE Mode).
Note:
• LOCAL: Operated using the keypad. Use the keypad to enter Run/Stop commands and
the frequency reference command.
• REMOTE: Operated from the control circuit terminal or serial transmission. Use the
frequency reference source entered in b1-01 and the Run command source selected in
b1-02.
Illuminated: The drive detects a fault.
OFF: There are no drive faults or alarms.
Flashing:
• An alarm
• Operation Errors
• An Auto-Tuning error
Note:
The LED will illuminate to identify a fault if the drive detects a fault and an alarm at the
same time.
Illuminated: The drive is operating or is prepared for operation.
OFF:
• The drive detects a fault.
• There is no fault and the drive received a Run command, but the drive cannot operate. For
example, in Programming Mode.
Flashing: The drive is in STo [Safe Torque OFF] state.
Flashing quickly: The voltage of the main circuit power supply decreased, and the external 24
V power supply provides the only power to the drive.
Function
on the keypad to set the
to stop the motor. This will also stop the motor
1 English
15