Use; Select Operating Mode; Select Direction Of Rotation; Switching On And Off - Parkside PBH 1050 B2 Originalbetriebsanleitung

Use

Select operating mode

Function selector:
♦ Press and hold the release button
function selector switch
selector switch so that the required symbol
engages at the arrow mark:
Function
Drilling/screwing
Hammer drilling
Chiselling
Chisel position adjust-
ment
Adjusting chisel position:
You can rotate the tool to the required position for
chiselling using this function .
♦ Turn the function selector switch
♦ Turn the tool in the tool holder
position .
♦ Turn the function selector switch
for the chiselling function .

Select direction of rotation

♦ Select the direction of rotation by adjusting the
right/left rotation switch
WARNING!
► The right/left running switch
be used / adjusted if the appliance is at a
standstill .
PBH 1050 B2
on the
. Turn the function
Symbol
to position .
to the required
to position
.
may only

Switching on and off

Switching the appliance on:
♦ Press the ON/OFF switch
Switching the appliance off:
♦ Release the ON/OFF switch
Switching to continuous operation:
♦ Press the ON/OFF switch
pressed position with the ON/OFF switch lock
button .
Switching off continuous operation:
♦ Press the ON/OFF switch
again .

Preselecting rotational speed

You can use the speed preselector wheel
preselect the rotational speed .
Level A (low rotational speed) up to level F (high
rotational speed) . The speed you select depends
on the material to be processed . Work out the right
setting with this practical test:
- Levels D–F: high rotational speed:
for hammer drilling/chiselling in concrete or
stone .
- Levels A–C: medium rotational speed:
for drilling in steel or wood .
NOTE
► The set speed is only reached in continuous
operation .
.
.
. Lock it in the
and release it
to
GB │ MT 27 ■
│