Adjustments - Jacobsen RANSOMES ZT220D W/61 REAR DISCHARGE Einrichtungs-, Ersatzteile- Und Wartungshandbuch

ZT 220D
Series
DECK LEVELING
a) Park the machine on a smooth, level surface.
Raise the deck to the transport position.
b) Lower the deck onto a set of equal height blocks
A under the rear corners of the deck. Place
another set of blocks B under the front of the
deck so that the deck top is pitched forward 1/8".
NOTE: The front and rear of the deck are at different
heights.
c) Measure the height of the blade cutting edge
above the ground. Remove pin C and set the
height of cut lever D to that height
d) Loosen the jam nuts on the height of cut clips
and adjusting screws E. Turn the adjusting
screws E until the play is taken out of the chains
at all four corners. Tighten the jam nuts against
the clips and at the adjusting screws.
COUNTERBALANCE SPRINGS
a) Raise the cutterdeck all the way.
b) Adjust the spring A with nut B:
61" cutterdecks to a length of 9-9/16" (242 mm)
The springs may be tightened or loosened from
this point according to personal preference.

ADJUSTMENTS

GB-19