RIB SUPER 2200 3P Bedienungsanleitung Seite 29

A - CONNEXIONS
T1
T2
JC
JB
JA
L1 - N 230Vac 50/60Hz POWER SUPPLY (TO BE DONE BY THE
J1
MANUFACTURER)
BLINKER (40 W MAX.)
U
J2 CONNECTION TO JC CONTACTS OF THE CARD R2
V-W
J3 PED. BUTT. PEDESTRIAN OPENING CONTACT (NO)
A+ TEST +24Vdc SAFETY STRIP SELF-TEST POWER SUPPLY
LSC CLOSE LIMIT SWITCH THAT CUTS OFF THE MOTOR IN CLOSING
COM LIMIT SWITCH COMMON CONTACT
LSO
OPEN LIMIT SWITCH THAT CUTS OFF THE MOTOR IN OPENING
STOP STOP CONTACT (NC)
J4
OPEN OPENING CONTACT (NC)
CLOSE CLOSING CONTACT (NC)
K. BUTT.
SINGLE PULSE CONTACT (NO)
A+ ACCESSORIES POWER SUPPLY +24Vdc
A- ACCESSORIES POWER SUPPLY -24Vdc
SIGNAL GATE OPEN INDICATOR 24Vdc
COM COMMON CONTACT (common line for all the command and safety
inputs)
EDGE NC SAFETY STRIP CONTACT (NC)
J5 AERIAL RADIO ANTENNA
COM COMMON CONTACT (common line for all the command and safety
inputs)
PHOTO NC PHOTOCELLS CONTACT (NC)
J6 PROBE IS NOT AVAILABLE
ENCODER
J7 IS NOT AVAILABLE
RADIO CONNECTOR FOR EXTERNAL RADIO RECEIVER 24Vdc
J8
S3 J7
J5
TR1
TR2
J4
J3
SW S1
J2
J1
S3
TR1
TR2
SW S1
SW1
SW2
SW3
T1 - T2
JA
JB
JC
29
29
J6
J8
SW1
SW2
SW3
PROG. PROGRAMMING BUTTON
LOW SPEED IS NOT AVAILABLE
TORQUE IS NOT AVAILABLE
SW S1 DO NOT REMOVE THE JUMPER!
OTHERWISE THE OPERATOR WILL NOT WORK!
DIP-SWITCHES
CARD R2
POWER RELAYS FOR THE COMMAND OF THE MOTOR
RST 3/PHASE PHASE POWER SUPPLY
N NEUTRAL
CONTACTS FOR THE EARTH CONECTION
MOTOR CONNECTION
U-V-W
SINGLE PHASE POWER SUPPLY FOR THE S1 CONTROL PANEL TO
L1-N
BE DONE BY THE MANUFACTURER
CONNECTION TO THE POWER RELAYS, TO BE DONE BY
X-Y-Z
THE MANUFACTURER
NC: NORMALLY CLOSED CONTACT
NO: NORMALLY OPEN CONTACT
IT IS COMPULSORY TO SET THE
DIP 13 OF THE CONTROL PANEL
IN THE ON POSITION.
G
B