Parkside PMNF 1350 D4 Originalbetriebsanleitung Seite 28

GB MT
such as grinding discs for chip-
ping or cracks, grinding plates
for cracks, wear or strong abra-
sion and wire brushes for loose
or broken wires before using
them. If the electric tool or the
attachment tool falls off, check
whether it is damaged or, use
an undamaged attachment tool.
If you have checked the attach-
ment tool and attached it, keep
yourself and any nearby persons
beyond the level of the rotating
attachment tool and allow the de-
vice to run for 1 min. at the high-
est rotational speed. Damaged tools
usually break during this test period.
i) Wear personal safety equip-
ment. Depending on the applica-
tion, use full face shields, eye
protection or safety goggles.
In so far as it is appropriate,
wear dust masks, ear protec-
tion, gloves or special aprons
which keep small grinding and
material particles away from
you. Eyes should be protected from the
foreign matter which can be caused to
ly during the various applications. Dust
or breathing masks should ilter the dust
that is created during operation. If you
are exposed to loud noise for a long
time, you may suffer hearing loss.
j) Ensure that other people are at
a safe distance to your work-
ing area. Anyone who enters the
working area should wear per-
sonal protective equipment. Broken
bits from the piece being worked or
broken attachment tools can ly away and
cause injuries even beyond the direct
working area.
28
k) Hold the electric tool only by the
insulated gripping surfaces when
performing work in which the
cutting tool may come into contact
with hidden wiring or its own
cord. Contact with a live wire can also
cause a charge in metal parts of the
device and result in an electric
l) Keep the cord away from the ro-
tating attachment tool. If you lose
control of the device, the power cord
can become separated or caught and
your hand or arm may be pulled into
the rotating attachment
m) Never put the electric tool down
before the attachment tool has
come to a full stop. The rotating at-
tachment tool can come into contact with
the surface upon which it is set, whereby
you could lose control of the electric
n) Never allow the electric tool to
run while you are carrying it.
Your clothing may accidentally come
into contact with the rotating attachment
tool and get caught and the attachment
tool could drill into your
o) Clean the ventilation slots of
your electric tool routinely. The
motor air pulls dust into the housing
and, should too much metallic dust col-
lect, could cause electrical
p) Never use the electric tool near
lammable material. Sparks could
ignite this material.
q) Do not use attachment tools
which require liquid coolant.
Using water or another liquid coolant
could lead to electrical shock.
shock.
tool.
tool.
body.
hazards.