Operation; Turning On And Off - Parkside PMNF 1350 D4 Originalbetriebsanleitung

GB MT
Attaching the vacuum cleaner
Unscrew the suction connector (10) cap.
Insert the industrial vacuum cleaner's hose
through the cap and screw the cap tight.
If your vacuum cleaner's hose is the wrong
diameter for a direct connection, you can
insert the vacuum adapter (11) in between
with a single turn.
Always attach a vacuum cleaner. Damage
to the motor caused by failure to attach
a vacuum cleaner is not covered by the
warranty.

Operation

Caution! Risk of injury!
- Always remove the mains plug
before working on the tool.
- Only use grinding discs and acces-
sories recommended by the manu-
facturer. Using other attachment
tools and other accessories can
represent a risk of injury for you.
- Only use grinding tools which
bear information about the
manufacturer, type of binding,
dimension and permitted number
of revolutions.
- Only use grinding discs where
the printed rotational speed is at
least as high as what has been
speciied on the name plate of
the device.
- Do not use any broken, cracked,
or otherwise damaged grinding
discs.
- Never operate the device with-
out protective equipment.
- Support the plates or workpieces
in order to reduce the risk of
32
kickback from a jammed cut-
ting disc. Large workpieces may
bend under their own weight.
The workpiece must be sup-
ported on both sides of the disc,
not only near the cutting disc,
but also at the edge.
Keep your hands away from
the disc when the device is in
operation. Risk of injury.
Switch the device off and remove
the mains plug. Allow the device to
cool down.
Notes on statics:
Slots in load-bearing walls are subject to
the standard DIN 1053 Part 1 or country-
speciic speciications. These rules must be
strictly adhered to. Before starting work,
consult the responsible structural engineer,
architect or the responsible construction
management.

Turning on and off

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
Connect the machine to the power
supply.
1. To start the device, push the switch
lock (3) forwards.
switch (2).
2. To turn it off, release the on-off button.
The device turns off.
After switching on the device, wait until the
device has reached its max. speed. Only
then should you start with the work.
Press the on/off