Setting The Groove Depth; Vacuuming - Parkside PMNF 1350 D4 Originalbetriebsanleitung

8. The take-up lange (19) can be left on
the take-up spindle (16).
If you remove the take-up lange (19),
make sure to position it correctly. The
take-up lange's (19) contouring must
face towards the motor. If you turn the
take-up lange (19), the take-up spin-
dle (16) must turn with it.
9. Position the desired cutting disk (8) on
the take-up lange (19).
10. Set the desired cutting width by select-
ing the spacer disks (20). Push the
spacer disks onto the take-up spindle
(16). This is followed by the lange
(21). This is followed by the second
cutting disk (8). All separator disks
(20) not used for setting the cutting
width must be pushed onto the take-up
spindle (16) after the second cutting
disk.
11. Reposition the threaded clamping
lange (17) on the take-up spindle
(16).
12. Press the spindle retaining tab (7),
and turn the take-up spindle (16) until
the spindle retainer ixes the take-up
spindle (16). Retighten the threaded
clamping lange (17) using the chuck
key (13). You can now release the
spindle retaining tab (7).
Information on replacement:
• Never operate the device without
protective equipment.
• Ensure that the rotation speed
stated on the grinding disc (8) is
the same or higher than the nomi-
nal rotation speed of the device.
• Ensure that the grinding disc dimen-
sions match those of the device.
• Only use lawless grinding discs
(ringing test: when you strike the
grinding disc with a plastic ham-
mer, it results in a clear sound).
• Never re-drill a locating hole which
is too small to make it larger.
• Never use separate bushings or
adapters in order to make grind-
ing discs with a hole that is too
large it the device.
• Do not use any saw blades.
Only replace the diamond
cutting disks in pairs.
If the direction of rotation is marked
on your cutting disc, make sure that
it matches the direction of rotation
mark on the tool.
Wear protective gloves when chang-
ing the discs in order to avoid cut-
ting damages.

Setting the groove depth

1. Release the retaining screw (18).
2. Set the depth-stop to the required
depth. Adjust the protective
guard (5) to do this.
3. Reattach the protective guard (5) with
the retaining screw (18).

Vacuuming

During operation, the wall chaser gene-
rates a large quantity of dust. You should
therefore wear a dust mask, and always
connect an industrial vacuum cleaner.
If the vacuum system malfunctions, pause
operation and clear the malfunction!
GB MT
31