Waste Disposal And Venvironmental Protection; Troubleshooting; Risk Of Electric Shock; Error Correction - Parkside PMNF 1350 D4 Originalbetriebsanleitung

GB MT
Waste disposal and en-
vironmental protection
Be environmentally friendly. Return the tool,
accessories and packaging to a recycling
centre when you have inished with them.
Electrical machines do not belong
with domestic waste.

Troubleshooting

Always unplug the shredder before working on it.

Risk of electric shock!

Problems
Device doesn't
start
Grinding tool
does not move al-
though the engine
is runningt
Engine is slower
and stops
Grinding disc
does not rotate
smoothly, abnor-
mal noises can be
heard
34
Possible Cause
Mains voltage missing
Main circuit breaker is
tripped
On/off switch (
be defective
Engine faulty
Threaded clamping lange
(17) is loose
Workpiece, remaining work-
pieces block drive
Device is overloaded
through workpiece
Threaded clamping lange
(17) is loose
Cutting discs are defective
• Hand over the device at an utilization
location. The plastic and metal parts em-
ployed can be separated out and thus
recycled use can be implemented. Ask
our Service-Center for details.
• Defective units returned to us will be dis-
posed of for free.

Error correction

Check the socket, mains cable, line,
mains plug, repairs to be carried
out by qualiied electrician if neces-
sary, check main circuit breaker.
2) may
Repair by Customer Care
Tighten threaded clamping lange
(17) (see „Changing disc")
Remove blockages
Reduce pressure on cutting tool
Workpiece unsuitable
Tighten threaded clamping lange
(17) (see „Changing disc")
Change cutting discs