Safety Instructions For Cutting - Parkside PMNF 1350 D4 Originalbetriebsanleitung

any other condition that may af-
fect the power tool's operation.
If damaged, have the power
tool repaired before use. Many
accidents are caused by poorly main-
tained power tools.
• Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, tak-
ing into account the working
conditions and the work to be
performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
Service:
• Have your power tool serviced
by a qualiied repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
Safety instructions for
cutting
a) The protective guard on the de-
vice must be securely fastened,
and adjusted to ensure maxi-
mum safety, i.e. the smallest
possible section of the abrasive
surface should be visible to the
user. Ensure that you and all
persons in the vicinity keep out
of the plane of the rotating disk.
The protective guard is designed to
protect users from lying debris and
accidental contact with the abrasive
surface.
b) Only use diamond cutting disks
with this tool. Attaching the acces-
sories to the device does not guarantee
safe operation.
The allowable rotation speed of
c)
the attachment tools must be at
least as high as the highest rota-
tion speed indicated on the elec-
tric tool. Accessories that run faster
than the allowable speed can break
and ly apart.
d) Schleifkörper dürfen nur für
die empfohlenen Einsatzmögli-
chkeiten verwendet werden.
Zum Beispiel: Schleifen Sie
nie mit der Seitenläche einer
Trennscheibe. Trennscheiben sind
zum Materialabtrag mit der Kante der
Scheibe bestimmt. Seitliche Kraftein-
wirkung auf diese Schleifkörper kann
sie zerbrechen.
e) Verwenden Sie immer unbeschä-
digte Spannlansche in der richti-
gen Größe und Form für die von
Ihnen gewählte Schleifscheibe.
Geeignete Flansche stützen die Schleif-
scheibe und verringern so die Gefahr
eines Schleifscheibenbruchs.
f) Außendurchmesser und Dicke
des Einsatzwerkzeugs müssen
den Maßangaben Ihres Elek-
trowerkzeugs entsprechen. Falsch
bemessene Einsatzwerkzeuge können
nicht ausreichend abgeschirmt oder
kontrolliert werden.
g) The cutting disks and langes
must it the grinding spindle pre-
cisely. Disks that do not it the grind-
ing spindle precisely rotate unevenly,
vibrate sharply and can lead to loss of
control.
h) Never use damaged attachment
tools. Check attachment tools
GB MT
27