General Safety Directions For Power Tools - Parkside PMNF 1350 D4 Originalbetriebsanleitung

Hazard symbol with infor-
mation on the prevention of
personal injury caused by
electric shock.
Precaution symbol (explanation of
precaution instead of exclamation
mark) with information on preven-
tion of harm / damage.
Switch the device off and remove
the mains plug. Allow the device to
cool down.
Connect the machine to the power
supply.
General Safety Directions for
Power Tools
WARNING! Read all safety
directions and instructions.
Omissions in the compliance with
safety directions and instructions
can cause electrical shock, ire
and/or severe injuries.
Retain all safety directions and in-
structions for future use.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool
or battery-operated (cordless) power tool).
Work area safety :
• Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
• Do not operate power tools in
explosive atmospheres, such as in
the presence of lammable Iiquids,
gases or dust. Power tools create
sparks which may ignite the dust or fumes.
• Keep children and bystanders
away while operating a power
tool. Distractions can cause you to lose
control.
Electrical safety :
CAUTION! The following states how
to avoid accidents and injuries due to
electric shock:
• Power tool plugs must match the
outlet. Never modify the plug in
any way. Do not use any adapt-
er plugs with earthed (ground-
ed) power tools. Unmodiied plugs
and matching outlets will reduce risk of
electric shock
• Avoid body contact with earthed
or grounded surfaces, such as
pipes, radiators, ranges and re-
frigerators. There is an increased risk
of electric shock if your body is earthed
or grounded.
• Do not expose power tools to
rain or wet conditions. Water
entering a power tool will increase the
risk of electric shock.
• Do not abuse the cord. Never
use the cord for carrying, pulling
or unplugging the power tool.
Keep cord away from heat, oil,
sharp edges or moving parts.
Damaged or entangled cords increase
the risk of electric shock.
• When operating a power tool
outdoors, use an extension cord
suitable for outdoor use. Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
• If operating a power tool in a
damp location is unavoidable,
use a residual current device
GB MT
25