Additional Safety Information; Residual Risks; Assembly; Installing/Changing Disc - Parkside PMNF 1350 D4 Originalbetriebsanleitung

GB MT
j) Be particularly careful for pocket cuts in
existing walls or other areas where you
cannot see what is there. The cutting
disc may cause a kickback when it cuts
into gas or water lines, electrical lines
or other hidden objects.
Additional safety
information
a) Approved cutting disk types:
segmented diamond disks with a
maximum space of 10 mm between
segments, only with a negative cutting
angle.
Disk diameter:
Disk thickness:

RESIDUAL RISKS

Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Lung damage if suitable respiratory pro-
tection is not worn.
b) Hearing damage if suitable ear protec-
tion is not worn.
c) Damage to health due to
- touching the area of the grinding tool
which is not covered;
- ejection of parts of workpieces or
damaged grinding discs.
d) Health injuries which result from swing-
ing hand and arm, in the
device is used over a longer period
of time or is not used and maintained
properly.
Warning! During operation, this
electric tool generates an electro-
magnetic ield which, under certain
30
125 mm
2,1 mm
event that the
circumstances, may impair the func-
tionality of active or passive medical
implants. To reduce the risk of seri-
ous or lethal injuries, we recommend
that persons with medical implants
consult their doctor and the manu-
facturer of their medical implant
before operating the machine.

Assembly

Caution! Risk of injury!
- Ensure that you have suficient
space in which to work, and that
you do not endanger other people.
- All hoods and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug before
changing the setting on the
device.

Installing/changing disc

1. Press the spindle stop button (7).
2. Turn the mounting spindle (16) until
the spindle lock ixed the mounting
spindle. Keep and continue to hold
down the spindle lock button (7).
3. Release the clamping nut (17) with the
chuck key (13). You can release the
spindle lock button (7.
4. Remove the threaded clamping lange
(17) through the opening in the protec-
tive guard (15).
5. Remove the cutting disk (8) by lifting
and pulling away the take-up spindle
(16) until it reaches the protective
guard.
6. Remove the lange (21) and the spac-
er disks (20) through the opening in
the protective guard (15).
7. Remove the second cutting disk (8) as
described in point 5.