Handling; Cleaning And Servicing; Cleaning; Storage - Parkside PMNF 1350 D4 Originalbetriebsanleitung

The disc still runs even after
the device has been switched
off. Risk of injury.
Trial run:
Always carry out a trial run before carry-
ing out your irst grinding procedure and
after every disc replacement. Switch the
device off immediately if the grinding disc
is not rotating smoothly, if considerable
vibration occurs or if you hear abnormal
noises.

Handling

Using a line locator, check the
walls for hidden electricity
cabling and gas and water
pipes before working with
the wall chaser.
1. Switch on the wall chaser, position the
start roller (9) against the wall while
the cutting disks are rotating.
2. Bring the cutting disks into contact
with the wall.
3. The cutting direction should always
be opposite to the disks' rotational
direction. Check the marking (14).
Otherwise, the wall chaser can be
pushed outside the cutting area in an
uncontrolled manner.
4. Once you reach the end of the
groove, remove the device from the
groove before switching it off.
5. Chip out the resulting ridge between
the two grooves using the hand chisel
(12).

Cleaning and servicing

Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this
instruction guide performed
by a professional. Only use
original parts. Allow the de-
vice to cool off before any
maintenance or cleaning is
undertaken. There is a risk of
burning!
Always check the device before using it for
obvious deiciencies such as loose, worn
or damaged parts, correct the position-
ing of screws or other parts. Examine the
grinding disc in particular. Exchange the
damaged parts.
If the replacement of the supply cord is
necessary, this has to be done by the
manufacturer or his agent in order to avoid
a safety hazard.

Cleaning

Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.

Storage

• Store the appliance in a dry place well
out of reach of children.
• Grinding discs must be dry and stored
upright and should never be stacked.
GB MT
33