Making Hot Frothed Milk - Silvercrest SMAI 550 A1 Bedienungsanleitung

Making hot frothed milk

1) If not yet attached: Insert the spiral coil
stirrer
2) Remove the jug
reach MIN mark inside the jug
mark
the volume of the milk increases significantly!
NOTE
► If there is not enough milk in the appliance, all three red symbols
and
you will hear 9 beeps. Add milk. Observe the MIN mark!
3) Place the jug
4) Put on the lid
5) Press the On/Off / programme selection button
fluffy froth. The symbol
Press the On/Off / programme selection button
dense froth. The symbol
The whisk will start rotating and frothing the milk and the milk is heated.
6) The appliance switches off as soon as the milk is frothed. The appropriate
symbol
a beep.
NOTE
► If you wish to stop the preparation process before completion, press the
On/Off / programme selection button
process, press the On/Off / programme selection
again until the symbol
will restart.
7) Wait about 30 seconds. During this time the still-liquid milk flows to the
bottom.
8) Remove the lid
Wait about 2 minutes before you froth up another portion of milk.
SMAI 550 A1
.
from the base
(350 ml). Otherwise, the appliance may overflow. When frothed,
will flash simultaneously shortly after you start the appliance and
on the base
with the stirrer
/ will flash for approximately 30 seconds and you will hear
and pour the milk froth into the desired container.
into the slots of the whisk on the
and add milk. Add enough milk to
(130 ml). Never exceed the lower MAX
.
.
lights up.
lights up.
. To restart the preparation
or lights up. The preparation process
,
once to produce
twice to produce
once or twice
GB │ IE │ 25 ■