SRAM P5 Handbuch Seite 12

Assembly
Caution:
The SRAM P5 hubs are not
suitable for tandems, trademen's
delivery bicycles and similar.
Caution:
The SRAM P5 Cargo is suitable
for tandems, trademen's delivery
bicycles and similar. An additional
external rear brake is necessary
due to the high load.
Indentification SRAM P5 Cargo:
Yello grub screw inside the axle end.
S H I F T E R A N D C L I C K B O X
• Slide shifter (1, Fig 5) onto
handlebar.
• Mount fixed grip (2) onto end
of handlebar.
• Slide shifter against fixed grip,
adjust shifter on handlebar and
tighten with bolt (3) with a
torque of 1.5 Nm (13 in. lbs.).
5
5
4
Caution:
• Check that the shifter and
brake lever function properly
and are unobstructed (realign
if necessary).
• Fixed grips provide an axial
safety function. For this reason,
they should be mounted in such
a way as to make sure they do
not slip off handlebar.
• Never use lubricants or sol-
vents to install fixed grips.
3
1
• When fitting the cable avoid
small radius. Attach the cable
3 times to the down tube.
• Last attachment point is on the
lower rear wheel fork immediately
behind the chain wheel.
Cable housing must be
movable inside attachment.
• Place shifter in gear position „2".
• Push on Clickbox (4, Fig. 5) to the
stop on the axle. The red guiding
rib of the locating sleeve thereby
engages in the slot on the housing.
• Tighten knurled bolt (5, Fig. 5)
by hand.
2