Technical Data; Manufacturer's Terms Of Warranty - Truma DuoControl Gebrauchsanweisung, Einbauanweisung

Technical data

measured measured according to EN 13786 or under
Truma test conditions
Gas type
Liquid gas (propane / butane)
Inlet pressure
0.6 – 16 bar
Outlet pressure
30 mbar or 50 mbar, according to variant
Flow rate
1.5 kg/h
Regulator inlet
Male thread M20 x 1.5 (G.13)
Regulator outlet
8 mm or 10 mm olive screw connection
Recommended tightening torque
3 – 5 Nm for nut M20 x 1.5 (G.13)
Declaration of conformity
The Truma DuoControl automatic changeover regulator com-
plies with pressure device guideline 97/23/EC, with EN 13786
Appendix B.
Product Identification Number
CE-0085BQ0102
DG approval number: 3894
The DuoControl automatic changeover regulator and its elec-
trical accessories components comply with the automotive
EMC directive 72/245/EEC supplemented by 2004/104/EC,
2005/83/EC and 2006/28/EC, and bears the type approval
number: e1 03 4352
The right to effect technical modifications is reserved!
16

Manufacturer's terms of warranty

1. Case of warranty
The manufacturer grants a warranty for malfunctions in the
appliance which are based on material or production faults.
In addition to this, the statutory warranty claims against the
seller remain valid.
A claim under warranty shall not pertain:
– for parts subject to wear and in cases of natural wear and
tear,
– as a result of using components in the units that are not
original Truma parts,
– as a result of damage caused by foreign substances (such
as oil, softener) in the gas,
– as a consequence of failure to respect Truma instructions
for installation and use,
– as a consequence of improper handling,
– as a consequence of improper transport packing.
2. Scope of warranty
The warranty is valid for malfunctions as stated under
item 1, which occur within 24 months after conclusion of
the purchase agreement between the seller and the final
consumer. The manufacturers will make good such defects
by subsequent fulfilment, i.e. at their discretion either by
repair or replacement. In the event of manufacturers provid-
ing service under warranty, the term of the warranty shall not
re commence anew with regard to the repaired or replaced
parts; rather, the old warranty period shall continue to run.