Restore The Factory Settings; Cycle Counter - Becker BOM 850C-II Handbuch

Restore the factory settings

1. Pull out the mains plug.
2. Press and hold the OPEN and CLOSE buttons at the same time.
3. Press the buttons for approximately 3 seconds after you put the power
plug into the electrical socket.

Cycle counter

The cycle counter stores the number of OPEN/CLOSE actions powered by the drive.
To read the meter, hold the button
The digital display shows the numbers starting from the highest to the lowest decimal place consecutively. At the
end, a horizontal line appears on the display, for example: 3456 movements, 3 4 5 6 -
in for 3 seconds until you see a number.
Diagnostic display
49