Program The Hand Transmitter - Becker BOM 850C-II Handbuch

Program the hand transmitter

Displays and button functions
I. Teach button on the radio receiver
II. Teach button at the transmitter
III. Channel selection button
IV. LED
V. DIP switch
DIP switch position ON: Defi ned motion commands UP, STOP, DOWN
DIP switch position 1: Pulse sequence UP-STOP-DOWN-STOP
Teach the radio connection
Note: Use a suitable cylindrical tool (e.g. a pen) to press the teach button at
the transmitter.
Teach the fi rst transmitter (master transmitter)
1. Press the teach button on the radio receiver (I) for 3 seconds. The LED (IV)
fl ashes and the radio receiver is ready for teaching for 3 minutes.
2. Then press the teach button at the transmitter (II) for 3 seconds.The LED at
the hand transmitter is illuminated for 3 seconds and the LED (IV) goes out.
Teach-in is now completed and the control returns to the normal operating
status.
Teach further transmitters
Note: In addition to the master transmitter, up to 7 transmitters can be taught
to the radio receiver.
1. Press the teach button (II) of the master transmitter for 3 seconds.
The LED (IV) lights up once for acknowledgement.
2. Now press the teach button of a new transmitter that is still unknown to the
radio receiver for 3 seconds.
The radio receiver is now ready to be taught a new transmitter for
3 minutes.
The LED (IV) lights up once for acknowledgement.
3. Press the teach button of the transmitter to be taught for 3 seconds once
again.
The LED (IV) lights up twice for acknowledgement.
The new transmitter has been taught.
Installation
I
IV
V
3 sec
3 sec
Nr. 1
No.
3 sec
No. Nr. 2
3 sec
No. Nr. 2
II
III
1 1x x
1x x
2x x
39