Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-16
Assembly
5. Place the centre of the base plate 2 on
this point and mark the 9 drill holes.
For concrete ceilings, mark 6 holes.
6. If the exhaust hood will be used to extract
air, also mark the opening for the exhaust
air hose on the ceiling.
7. Drill the holes in the ceiling at the marked
points.
8. Insert 9 suitable wall plugs into the drilled
holes.
Assembling the exhaust hood
NOTICE
Risk of damage to property!
Improper handling of the appliance
can lead to property damage.
When lifting and carrying the ex-
■
haust hood, always carry it by the
housing and never by the glass cover!
This could otherwise break.
1. Place the exhaust hood 1 on the floor with
the grease filter 13 facing upwards.
2. Release knurled screw 14 and slightly
lift the grease filter 13, pull it out of the
groove and put it to one side.
3. Remove the LED light tube 15 from the
exhaust hood 1 and put it to one side.
16
4. Remove the two screws 16 and open the
plug box 17.
13
1
14
5. Press the plug locking mechanism and
disconnect the plug for the LED power
supply.
15
1
17
Werbung
Kapitel
Inhaltsverzeichnis
