Stand-Alone Mode - EuroLite LED KLS-170 Bedienungsanleitung

Notes
• Approx. 5 seconds after pressing the last button, the setting procedure in the sub menus is aborted.
• SLAV or d*** modes: If no control signals are available, the display will be flashing.
• While menu AutP, AutF, AutM, SouP, SouF or SouM is selected, all LEDs are switched off; in the sub
menus they will be switched on again.
• The sync mode is a new functionality for Eurolite devices. Similar to the master/slave operation, it is
possible to interconnect several devices and control them collectively. If one device is set to sync mode, all
other units will respond to its control signals (from 10 devices).

Stand-alone mode

Automatic mode
In automatic mode, different show programs are available that run at an adjustable speed.
1 Press the MENU button so many times until Aut for automatic mode is indicated in the display. Confirm
with the ENTER button.
2 Use the ▲ and ▼ buttons to select the desired program mode: AutP = spots, AutF = strobe LEDs or
AutM for a combination of all devices. Confirm with ENTER.
3 Use ▲ and ▼ to select the number of the desired program. Confirm with ENTER. The display indicates
menu item running speed.
4 Use ▲ and ▼ to adjust the running speed of the program from S.01 (slow) to S.99 (fast). Confirm with
ENTER.
Sound control
Via the integrated microphone the unit can perfectly reproduce the show programs to the rhythm of the
music (sufficient bass provided).
1 Press the MENU button so many times until Sou for sound control is indicated in the display. Confirm
with the ENTER button.
2 Use the ▲ and ▼ buttons to select the desired program mode: SouP = spots, SouF = strobe LEDs or
SouM for a combination of all devices. Confirm with ENTER.
3 Use ▲ and ▼ to select the number of the desired program. Confirm with ENTER.
4 Adjust the microphone sensitivity to the volume of the music with the SENSITIVITY control. The LEDs do
no light if the volume is too low or if there is no sufficient bass beat.
Individual color mix
In the color mode CoLo the white and UV strobe LEDs light and the spots light constantly in red, green and
blue. It is possible to adjust the flash frequency of the strobe LEDs and the brightness of the spots.
1 Press the button MENU so many times until CoL is indicated in the display. Confirm with the ENTER
button. The display indicates CoLo.
2 Press ENTER. Now the display indicates the letter R for the color and the corresponding brightness
value.
3 Use the ▲ and ▼ buttons to adjust the desired brightness.
4 Confirm with ENTER. Now the color green can be adjusted; then blue.
5 The stetting of the strobe LEDs is the final menu item. Use ▲ and ▼ to select the number of the desired
flash frequency from S.01 (slow) to S.99 (fast).
24/32
00121009, Version 1.1