Adjusting The Conveyor Belt Tracking & Tension - Holzmann ZS640P Bedienungsanleitung

13.6 Adjusting the conveyor belt tracking & tension
If the conveyor belt runs to the right or left during operation, or the conveyor belt tension is too
loose or too tight, adjust it by turning the adjustment nuts on either side of the conveyor table.
The conveyor belt should run at the center of the conveyor table, and should be tensioned so that
there is good traction during stock feeding.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CAUTION
Make sure the machine is disconnected from
the power source before mounting the sand-
ing belt.
Zylinderschleifmaschine/ mini wide belt sander ZS640P/ZS970P
ASSEMBLY
Seite 29