Assembling/Dismantling The Two-Piece Blow Tube; Assembling/Dismantling The Two-Piece Suction Tube - FLORABEST FLS 3000 B2 Originalbetriebsanleitung

sembly of the blower pipe,
suction pipe, protective cover
or collection bag, the engi-
ne must be turned off and
all moving parts must have
come to a standstill.
Always disconnect the plug
from the mains socket before
working.
Assembling/dismantling the
two-piece blow tube
Never use the leaf blower
with only one blower tube
section attached. There is a
risk of personal injury!
1. Assemble the two-piece blow
tube (9) as illustrated. The parts
can be felt to lock into place.
During assembly, make sure that
the groove on the upper section
of the blower tube is inserted into
the recess provided on the lower
section of the blower tube.
2. Now push the blow tube (9) on
to the blowing aperture of the
motor housing (1) as far as the
locking device (8).
3. Place the protective cover of the
suction opening (7) on the under-
side of the motor housing. Turn
the protective cover clockwise as
far as it will go.
4. Attach the protective cover by
tightening the screw with star grip
(18) in the holder.
The screw with star grip has to be
tightened as far as it will go by
hand, as otherwise the leaf blower
cannot be started later.
5. Dismantle the blow tube (9) by
releasing the lock (8) and pulling
off the blow tube forwards.
Assembling/dismantling the
two-piece suction tube
Never use the leaf vacuum
with only one suction tube
section attached. There is a
risk of personal injury!
After the two-part suction
tube has been assembled, it
must not be divided up again
into two parts!
1. Remove the protective cover of the
suction opening by unscrewing
the screw with star grip (18) and
turning the protective cover anti-
clockwise and removing it.
2. Assemble the two suction tubes
(16) as illustrated. The parts can
be felt to lock into place.
During assembly, make sure that
the groove on the upper section
of the suction tube is inserted into
the recess provided on the lower
section of the suction tube.
3. Place the suction tube (16) on the
underside of the motor housing
(1). Turn the suction tube clock-
wise as far as it will go.
4. Attach the suction tube by tighte-
ning the screw with star grip (13)
in the holder.
The screw with star grip has to be
tightened as far as it will go by
hand, as otherwise the leaf vacuum
cannot be started later.
GB IE
11