Cleaning And Maintenance; Cleaning - FLORABEST FLS 3000 B2 Originalbetriebsanleitung

GB IE
• Always hold the device tight with both
hands during operation: use the handle
(3) and the additional handle (10) for
this.
• Make sure the volumes of leaf material
sucked in at one time are not too large.
This will avoid clogging of the suction
tube (16) and blockage of the impeller
wheel.
To reduce wear on the collection
bag, do not drag it along the
ground while working.
Overload protection: The motor
will cut out immediately if overloaded.
Turn the leaf vacuum off and remove
the mains plug. Then check whether
the impeller is blocked or the collec-
tion bag clogged and remove the
obstacles if they are.
The tool cannot be used until it has
completely cooled down again.
Emptying the collection bag:
With full collection bag, the suction pump-
ing capacity decreases considerably and
the collection bag must be emptied when
the bag is full or interferes with the suction
capacity of the device.
1. Turn off the device and wait until
the impeller has stopped.
2. Unplug the device.
C 3. Remove the attachment eyes (15) D E
from the holding points (19).
Release the collection bag by
M N O
pressing the locking button (8).
4. Open the zip-fastener on the collec-
W X Y
tion bag and empty it completely.
5. Mount the emptied collection
bag again.
14
F G H
P Q R
Z
Composting material does not be-
long with domestic waste!
Cleaning and
maintenance
Always clean the device
immediately after working with
it, as otherwise dirt will become
hardened and firmly attached
with leaf residues and might prove
impossible to remove without
dismantling the motor housing. Such
cleaning work is not covered by the
warranty.
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing and remove the
mains plug
Do not use any cleaning agents or
solvents. Chemical substances may
attack the plastic parts of the de-
vice.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

I J
Do not spray the appliance
with water and do not im-
S T
merse it in water. Electric
shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.