Controls Before Operational Start-Up; Operation; Mains Connection; Switching On And Off - FLORABEST FTP 400 D3 Originalbetriebsanleitung

GB IE NI
If the water level is too low, the silt
in the shaft can quickly dry out and
impede the pump when warming
up.
Controls before operational
start-up
working (see chapter: "Opera-
tion").
• Check that the pump is resting
on the pit base
• Check that the pressure line has
been attached properly
• Check the proper status of the
electrical plug socket and make
sure that the plug socket is suf-
sert the pump plug into the plug
socket and the pump is ready for

operation.

• Make sure that moisture or water
never come in contact with the
of electrocution.
Operation

Mains connection

you is already provided with an grounded
plug.
nection to an earthed wall socket with a
residual current operated device (RCD
Only start to operate the device
after all the above conditions have
been observed.
10

Switching on and off

1
starts working immediately.
when the swimming switch is in the
correct position (see „Automatic opera-
tion" and „Manual operation").
If the water level is too low, the
switch off the pump.
Supervise the appliance while it is
in operation in order to be immedi-
ately aware if the automatic cut-out
- operates or the pump runs dry, to
limit any damage to a minimum.

Automatic mode

automatically switches the pump on or off.
In the case of stationary installation,
check regularly (no less then once
switch (
(
-
height adjustment (7) and move it
to the desired position.
- It must be positioned so that it
switching point heights "On"
and "Off" must be easy to
reach.
6) is working.
6)