Adjusting The Table Height - ATIKA ASP 10 N Bedienungsanleitung

Adjusting the table height

Upper table plate position for logs up to 590 mm.
Middle table position for logs up to 900 mm.
Lower base position for logs up to 1325 cm.
1. Split logs up to 590 mm on the table plate.
Secure the table plate using the locking bolt.
(The locking bolt engages in the table plate hole.)
2. Split logs up to 900 mm on the table. Pull out the table
plate.
3. Split logs up to 1325 mm on the base. Press the locking
lever down and swing aside the table.
Locking lever
Adjusting the splitting cross:
1. Loosen star grip
screw.
2. Move the splitting
cross to the
correct position
(The star grip
screw is beyond
Splitting cross
the borehole in
the splitting
blade).
3. Mount star grip screw.
Splitting short wood:
1. Upper position of table plate.
2.
Place the log on the splitter's table plate.
Locking bolt
Table plate
Table
Base
Star grip screw
Only split the logs in the direction of the wood fibres.
3. Hold the log tight with the clamping claws.
Splitting long wood:
1. Middle position
of table or low
position of base.
2. Remove the
splitting cross.
3. Place the log on
the splitter's
table or base.
Possible malfunction when cleaving logs: The log to
be cleaved is not cleaved right through, jams on the cleaving
blade and is pulled up during the blade's return movement.
In this case, proceed as follows:
1. Switch off the device.
2. Depending on the log still to be cleaved fix the table plate
in the upper or the table in the middle position.
3. Switch on the device and continue the splitting operation.
Never try to split two logs at once.
Never try to remove or replace the log during the
splitting process.
Never try to force the splitting of the log by maintaining
the pressure for several seconds. This can lead to damage
to the machine.
Position the log on the table again and repeat the splitting
phase, or put the log on one side.
How to release a jammed log?
There is a risk of knotted logs getting stuck during the
splitting process.
1. Switch machine off and disconnect the power.
2. Do not remove jammed logs with your hand
3. Carefully move the stuck log with a crowbar backwards
and forwards to loosen it. Don´t damage the splitting
pillar.
Never hammer on the stuck log.
Never use a saw to cut the stuck log out of the machine.
Do not enlist the aid of a second person - this is a one-
man job.
s.
23